By wetting down the vinyl first you are able to reposition your graphics during application.
Wet apply vinyl decals.
Industry experts walk you through wet vinyl applications from routine to the most extreme of installation conditions.
Tape the decal at the top edge using the biggest masking tape you can find.
Enjoy your new vinyl.
Begin to apply vinyl to the vehicle.
Big tape at top leave the decal attached to the wax paper.
The wet application method applies a vinyl graphic to a substrate by using a fluid to assist with positioning.
All dirt and wax must be removed to give the vinyl proper surface to adhere to wiping area with rubbing alcohol will give you really good stick 2.
Learn how rapid remover works so effectively at removing residue adhesive and even see how rapid tac ii application fluid makes easy work out of applying calendered film on glass outdoors while it s snowing.
Apply the sticker while the area is still wet.
Those who are still learning need the flexibility that wetting solutions can offer.
Face the decal with the tissue paper cover toward you.
The wet method involves making a soap solution using a mixture of dish soap and water to get both the application surface and the adhesive side of the decal wet before applying the decal.
The only difference is the application of soapy water to the vinyl before application.
You can apply most smaller decals without using water but for large and very large stickers this trick is a life saver.
Please take your time.
After cleaning your surface area wet the area again using a spray bottle and a solution of about 5 soap 95 water.
Just a little bit of dish soap in water is all you need to help install without bubbles.
Remember you cannot get the graphics too wet.
How to apply vinyl decals using dry method 1.
Clean the area that the vinyl will be applied.
Slower than the dry method but no air bubbles.
Remove protective backing from vinyl.
The key to this method is keeping both your vinyls and your application surface wet.